Sheet Metal Fabrication for Medical
K-Display's medical sheet metal fabrication supplies equipment carts, instrument housings, enclosures, and frames for medical device and laboratory equipment makers, in stainless steel or carbon steel. Parts are welded, powder coated, and marked in Chicago from your drawings.
Carts, housings, enclosures and frames for medical equipment
K-Display supplies equipment carts, analyzer housings, control enclosures, bed bases, and nurse-station cabinets in stainless steel or carbon steel, powder coated, with casters, hinges, and latches installed. Cart frames are the clearest case in medical sheet metal fabrication: IEC 60601-1 requires mobile equipment not to overbalance in any transport position of normal use on a plane inclined 10 degrees from horizontal. Base footprint and caster-plate spread decide whether a cart stays upright on that slope, so we weld the frame to the footprint you give. Housings, enclosures, and bed bases are formed and welded, then supplied as kits, subassemblies, or finished units.
The base deck sets the cart's stance, and the uprights set how high each shelf sits above it. Setting the top shelf lower steadies the cart on a slope without changing the base.
What we make for medical
- Equipment carts and mobile stands
- Welded or bolted frames, columns, shelves, and caster plates for monitoring and imaging carts.
- Analyzer and diagnostic housings
- Formed housings around laboratory analyzers and diagnostic instruments, with display, port, and vent cutouts and a side cover that comes off for service.
- Electrical and control enclosures
- Power and control boxes for imaging systems, patient monitors, and diagnostic equipment, with mounting panels and cable entries.
- Equipment frames and bed bases
- Welded steel bases and support frames under patient-handling and treatment equipment, drilled for its mounting pattern.
- Nurse-station cabinets
- Wall-mounted cabinets and charting stations in steel or stainless steel, with shelves, metal work surfaces, and cutouts for the cabling behind them.
- Trays, drawers, and internal brackets
- Drawer bodies, sliding trays, and mounting brackets for instruments and consumables, with deburred edges.
What medical jobs require
- Cart geometry and caster mounting
- Frame geometry, base footprint, and caster mounting pattern, with the load the cart carries.
- Wiped-surface material and finish
- Stainless steel or carbon steel, the powder coat system and gloss, and the disinfectant the surface is wiped with, since the service environment sets the coating system.
- Revision and marking
- The drawing revision on the order, the part identification, and the label or decal artwork with its location.
- Cutouts and bonding points
- Display, port, and vent cutout positions, and the location and stud size of each bonding point.
- Thickness and weld details
- Thickness for each part, with weld locations and the contour the specified welds are blended or ground to.
- Hardware and purchased components
- Casters, hinges, latches, and handles by manufacturer and part number, and the purchased components in the bill of materials, with who supplies each.
A side cover lifts straight off its tabs, and nothing on the housing stands in that path. The cover leaves the vent and port faces untouched, so the service opening stays clear.
How medical work runs
Cut, form, and weld the frames
We laser cut and form the sheet, then MIG and TIG weld the carts, frames, and housings.
Blend, fit hardware, then coat
We blend or grind the welds you specify so wiped surfaces stay smooth, install self-clinching hardware, and mask the bonding points before powder coat. We apply marking to the finished surface.
Assemble to the bill of materials
We assemble purchased components to your bill of materials, label each unit, and pack carts and housings with their hardware kitted.